The Firing Line Forums

Go Back   The Firing Line Forums > The North Corral > Black Powder and Cowboy Action Shooting

Reply
 
Thread Tools Search this Thread
Old May 27, 2012, 08:31 PM   #1
ZVP
Senior Member
 
Join Date: June 20, 2009
Posts: 1,102
Light powder charges in .44

Today I finally got to try some light Powder charges (Pyrodex) in my Brass Frame Piettia '52 Replica.
Unfortunatelly I didn't have a chrony to get reads from.
I started off with a 13gr load, COW filler Wad and a .454 ball. The shot was very weak though it cleared the barrel easilly, it struck some 2 1/2" high above the POA @ 7 yards. Very low report, more of a "Puff" than a bang. I watched carefully for each ball to pass thru the paper and strike the levy behind it to be sure it cleared the BBL.
Next I moved up to 15 gr COW filler same balls and wads. The discharge was more solid and it also struck 2 1/2" high. The Muzzle report was more of a bang this time and felt more solid.
Both light loads were just for test purposes as I had read the loads in suggested in factory literature and in my opnion both are just too light for any pratical use as they strike way too high to easilly estimate. I am sure velocities were very low on the tighter fitting .454 Balls and I am sure penetration on small game might be minimal or even usefull.
I have decided to stick with my tried and true 20 gr load as it seems to fire very well with a flatter trajectory and enough velocity to likely make it a good small game killer out to 30 yards. The load strikes about 1/2" high @7yards and targeting it is easy. Discharge is solid and report involves a nice "crack" indicating good ignition.
I just had to try these light loads just because you never know with BP or Substitutes, you just might get an accurate load even on the low speed end of the scale...
Just wanted to share this experiment with ya'll!
ZVP
ZVP is offline  
Old May 28, 2012, 01:48 AM   #2
zullo74
Junior member
 
Join Date: August 8, 2009
Posts: 374
What is a 'Brass Frame Piettia '52 Replica' ?
zullo74 is offline  
Old May 28, 2012, 11:38 AM   #3
buckhorn
Senior Member
 
Join Date: May 11, 2012
Location: mid michigan
Posts: 196
Brass framed "52"

I like, zullo74, would like to know what a "BRASS FRAMED '52" is. Maybe I missed something in my Black Powder primer from grade-school. Perhaps, you misquoted. or meant something else. At any case you have to be very careful with brass framed revolvers. They're not meant to take any but the minimum charge if you expect it to last, or not shoot loose. I love the look of brass framed revovlers, but I never bought one because I like historical accuracy, and the only brass framed revolvers were made in small quantities by the south during the civil war. Nothing cheese's me off more than watching a recently made western movie where the hero is walking around with a brass-framed 1858 remeington or navy colt.

Last edited by buckhorn; May 28, 2012 at 11:47 AM.
buckhorn is offline  
Old May 28, 2012, 12:48 PM   #4
Hawg
Senior Member
 
Join Date: September 8, 2007
Location: Mississippi
Posts: 16,175
I'm sure he meant 51.
Hawg is offline  
Old May 28, 2012, 01:12 PM   #5
zullo74
Junior member
 
Join Date: August 8, 2009
Posts: 374
How are you so sure? Is he your brother?
zullo74 is offline  
Old May 28, 2012, 01:43 PM   #6
buckhorn
Senior Member
 
Join Date: May 11, 2012
Location: mid michigan
Posts: 196
1852 brass frame

I'm sure he meant '51 also. The 1 and the 2 are up in the corner of your key board, and god knows I hit enough wrong keys to know.
buckhorn is offline  
Old May 28, 2012, 02:36 PM   #7
Hawg
Senior Member
 
Join Date: September 8, 2007
Location: Mississippi
Posts: 16,175
No, not related.
Hawg is offline  
Old May 28, 2012, 02:39 PM   #8
zullo74
Junior member
 
Join Date: August 8, 2009
Posts: 374
I thought you must be his identical twin since you are SURE what he meant.
zullo74 is offline  
Old May 28, 2012, 02:43 PM   #9
Hawg
Senior Member
 
Join Date: September 8, 2007
Location: Mississippi
Posts: 16,175
Quote:
I thought you must be his identical twin since you are SURE what he meant.
Well it was a figure of speech but I'd put money on it............If I had any to put on it.
Hawg is offline  
Old May 28, 2012, 05:20 PM   #10
capper
Member
 
Join Date: April 2, 2012
Location: Turners Falls, MA
Posts: 63
Hawg knows what he's talking about. I say 51' also.
__________________
Mmmm, how I love the smell of black powder in the morning!
capper is offline  
Old May 28, 2012, 05:24 PM   #11
zullo74
Junior member
 
Join Date: August 8, 2009
Posts: 374
I think you guy should let ZVP answer for himself.
zullo74 is offline  
Old May 28, 2012, 05:40 PM   #12
Beagle333
Senior Member
 
Join Date: January 7, 2012
Location: Auburn, AL.
Posts: 2,332
ooh, ooh... lemme play!!

I'm gonna join the madness too an say it's a '58.
If he's a hunt-and-peck typist like most, he would have used the number pad and just went down one instead of up one after he hit the "5" key.
Beagle333 is offline  
Old May 28, 2012, 05:48 PM   #13
Hawg
Senior Member
 
Join Date: September 8, 2007
Location: Mississippi
Posts: 16,175
Quote:
I think you guy should let ZVP answer for himself.
What freakin difference does it make what it was? You need to lighten up dude
Hawg is offline  
Old May 28, 2012, 11:56 PM   #14
ZVP
Senior Member
 
Join Date: June 20, 2009
Posts: 1,102
Yep '51

Just a little mis-typed jumber but you guys don't miss a thing or let it go without pokin fun at the dummy who can't type!
Yep, I admit it I type LOUSY but have good intentions...
Anyhoo, the light charges CAN even go a little too light and fail to clear the barrel and such, so it behooves us to carefully and lightly load all Brass Framed revolvers!
I have had good luck with this one at a 20 gr load. I use a little COW for filler to move the balls closer to the forcing cone. I don't like to have the balls travel too far to get to the cone for accuracys sake. This revolver groups best loaded this way.
I haven't seen any movie guns with Brass Frames but I'm sure some cheapo armorer has used em.
Thanks for the replies and belief that I mistyped!
ZVP
ZVP is offline  
Old May 29, 2012, 06:07 AM   #15
mykeal
Senior Member
 
Join Date: October 8, 2006
Location: Northern Michigan
Posts: 2,772
You guys are all just jealous that he really has a '52 replica and you don't.
mykeal is offline  
Old May 29, 2012, 06:30 AM   #16
noelf2
Senior Member
 
Join Date: April 14, 2008
Location: Stuart, VA
Posts: 2,473
I'm still curious about the "piettia" part. I'm thinking that's a typo for uberti..
__________________
Liberty and freedom often offends those who understand neither.
noelf2 is offline  
Old May 30, 2012, 09:12 AM   #17
Rifleman1776
Senior Member
 
Join Date: April 25, 2010
Location: Arkansas
Posts: 3,309
Quote:
just too light for any pratical use as they strike way too high
Those oldy style C&B revolvers will all shoot high until sights are changed. Suggest you read up why.
Low charges, in any pistol, oldy or modern, will shoot low.
Heavier charges and/or projectiles will shoot higher since the barrel begins to rise before the bullet/ball has left the muzzle.
Rifleman1776 is offline  
Old May 30, 2012, 09:25 AM   #18
zullo74
Junior member
 
Join Date: August 8, 2009
Posts: 374
I disagree for the very reason you gave..."the barrel begins to rise before the bullet/ball has left the muzzle." With a light charge, the bullet is in the barrel longer while the muzzle is rising, so they hit higher.
zullo74 is offline  
Old May 30, 2012, 02:53 PM   #19
steelbird
Senior Member
 
Join Date: July 19, 2010
Posts: 180
I also shoot 20 grain light loads in my 58 remmie, so you're not alone, ZVP. It does help improve accuracy, and helps keep powder costs down ( although I think I'm about to blow a hole in the powder budget thanks to my getting an Uberti Cattleman for BP loads.... Smokeless just doesn't seem right in these old school guns ). I think that the original loads during the Civil War were also light, so that's in keeping with the historic feel of these guns.
steelbird is offline  
Old June 4, 2012, 02:20 PM   #20
crstrode
Member
 
Join Date: August 13, 2008
Posts: 41
'52 Navy Colt

The little known '52 Navy was Saml. Colt's secret weapon, it actually shot about a foot low at fightin' distance. Hickok had a '51 and a '52 - that's why he never missed.
crstrode is offline  
Reply

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 12:25 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2021 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Page generated in 0.07144 seconds with 10 queries