|
Forum Rules | Firearms Safety | Firearms Photos | Links | Library | Lost Password | Email Changes |
Register | FAQ | Calendar | Today's Posts | Search |
|
Thread Tools | Search this Thread |
October 31, 2010, 10:45 PM | #1 |
Senior Member
Join Date: January 29, 2009
Location: Texas
Posts: 256
|
Strange problem with Pietta 1858
I was taking out the main spring (hammer spring) to try a new one that I bought to see about lightening the pull and found that when the the new one was put in I found a strange problem. When the tension screw that holds the spring in place was tightened all the way down as far as it would go and the hammer was cocked back the whole way ite spring would pop off of the hammer back towards the rear of the gun and the gun would not function until it was taken out and tried again. this kept happening and so I put the original side by side with it. The were the same lenght and the curvature was approx. the same. I put the original back in and found that it did the same. the only way to keep this from happening was to back the tension off so that the screw was slightly sticking out above the surface of the hand grip frame. I had never noticed this position before but it must have been this way all along. I can solve the problem bu shortening the screw a little but i was wondering if anyone else has experienced this.
__________________
God is fluxing me which is good but it is not fun. |
November 1, 2010, 12:09 AM | #2 |
Senior Member
Join Date: March 15, 2005
Location: Central Connecticut
Posts: 3,166
|
Here's someone whose 1858 didn't index right until the mainspring screw was tightened 1/2 turn.
http://www.thehighroad.org/showthrea...ade+mainspring Notice the different thicknesses of the Colt mainsprings pictured in this next thread. Would thinning one of your mainsprings produce the desired effect? http://www.thehighroad.org/showthrea...ade+mainspring |
November 1, 2010, 12:19 AM | #3 |
Senior Member
Join Date: October 24, 2008
Location: Naples, Fl
Posts: 5,440
|
Mrappe
Yep. I have had the effect on one of my Remingtons (1858) plus I did a modification on an 1863 putting a screw in the frame just like the 1858. I had to mess with that screw a little too. One other poster here spoke of it as well. I corrected the problem on mine by doing just as you say.
The screw head sticking out makes the pistol uncomfortable and distracting to hold.
__________________
Seek truth. Relax. Take a breath. |
November 1, 2010, 02:41 AM | #4 |
Senior Member
Join Date: February 24, 2009
Posts: 727
|
You could also try putting a spacer in the spring slot below the spring, in effect lengthening the spring so it doesn't pop out. Perhaps a piece of wood or leather cut to fit snugly.
|
November 2, 2010, 10:01 AM | #5 |
Junior Member
Join Date: July 29, 2010
Posts: 7
|
Just from experience Is the right screw in that position?
|
|
|