|
Forum Rules | Firearms Safety | Firearms Photos | Links | Library | Lost Password | Email Changes |
Register | FAQ | Calendar | Today's Posts | Search |
|
Thread Tools | Search this Thread |
March 16, 1999, 05:55 PM | #1 |
Junior member
Join Date: November 30, 1998
Location: Minnesota
Posts: 920
|
What kind of effort is involved?
How much do dies cost for sngle-stage/progressive Dillon loaders, approximately? Does anyone have use for once-fired brass? ------------------ Cornered "but cheery" Rat http://ddb.com/RKBA |
March 17, 1999, 07:39 AM | #2 |
Senior Member
Join Date: January 23, 1999
Location: Southern Iowa
Posts: 211
|
The dies all have the same tread these days so any New Dies you buy will fit any of the Newer Presses. ( I think most standardized in the 50's or 60's) Cost is around $25.00 less if you shop around.
Brass can be picked up at nearly any gun show at fairly low cost. Remember nominal Groove Diameter of the .303 Brit. is .312. not .308. Most bullet makers in this country make bullets for the .303 british. The easiest powder to use that my book shows is Hodgdon H-380, just because Ball powders meter so nice in the powder measure. the 150 grain Speer bullet starts at 42.0 grains of H-380 (2309 fps)and max is 47.0 grains (2570 fps) 180 grain Remington bullet starts at 41 grain H-380 (2127 fps) and max is 45.0 grains (2369 fps) 215 grain Remington bullet starts at 40.0 grains (2028 FPS) and max is 43.0 Grains (2150 fps) This data is from the Lyman 47th Reloading book I would suggest that this book is a good buy for any reloader. Buy the 48th if it is out. [This message has been edited by Raymond VanDerLinden (edited March 17, 1999).] |
March 17, 1999, 12:32 PM | #3 |
Staff Alumnus
Join Date: October 12, 1998
Location: Missouri
Posts: 1,992
|
A guy at my club reloads the .303. He warns about case seperation. According to him the case has a slight taper which can cause expansion problems with case seperation a definite possibility after 1 or 2 reloadings, even with reduced loads. He trashes his brass after 2 reloadings (unless they don't last that long).
I usually shoot surplus in my Enfields. |
March 17, 1999, 02:18 PM | #4 |
Junior member
Join Date: November 30, 1998
Location: Minnesota
Posts: 920
|
I shoot (mostly) surplus...but all my stuff comes in reloadable boxer-primed brass...I wanted to know if it would be of use to any reloaders out there...
|
March 18, 1999, 11:51 AM | #5 |
Staff Alumnus
Join Date: October 12, 1998
Location: Missouri
Posts: 1,992
|
I know what you mean about having brass laying around. I've got boxes upon boxes of different caliber brass in my basement that "someday" I'll get around to reloading, maybe.
|
March 20, 1999, 10:42 AM | #6 |
Member
Join Date: March 7, 1999
Location: Rome, NY, USA
Posts: 16
|
Theres some .303 loads listed on
www.reloadammo.com Lots of other loads listed there too.. TTFN |
|
|