January 23, 2006, 04:42 AM | #1 |
Member
Join Date: May 28, 2004
Location: Australia
Posts: 50
|
T7 Redding
Gentlemen. Recently I purchased a T7 turret to accomodate some extra
reloading. Already have a T6 Redding turret press and it has been faultless. After mounting the T7 it would not accept a shellholder. I tried 4 different manufacturers including Redding with no success. Anyone have a similar issue. Thanks Sean
__________________
Clean up your own mess |
January 23, 2006, 10:54 AM | #2 |
Senior Member
Join Date: April 29, 2001
Location: Where the Red Sox meet the Black Bears
Posts: 561
|
Sean, did you push it in hard?
|
January 24, 2006, 11:54 AM | #3 |
Senior Member
Join Date: January 1, 2000
Location: Roanoke, Virginia
Posts: 2,678
|
T7 Redding shell holder
First contact Redding and see what they say do.
I have a Lyman T-Mag press the shell holder would not fit on to. I took a file and went over the top of the ram. I took it down until A SHELL HOLDER would fit. I left things very stiff, so the shell holder would not fall off the ram. |
January 25, 2006, 04:26 AM | #4 |
Member
Join Date: May 28, 2004
Location: Australia
Posts: 50
|
Without going over the top I did try reasonable force
Didnt want to attack the ram with a file as this will void warranty. Just interested to hear if anyone had a similar problem. thanks Sean
__________________
Clean up your own mess |
January 29, 2006, 05:50 PM | #5 |
Junior Member
Join Date: February 24, 2005
Posts: 3
|
t-7
I also have two redding turret presses and have no problems with the shellholders. The t-7 dose take a good amoumt of presure to seat the shellholder in the ram. Call the factory and see if they have a solution.Duke45
|
January 29, 2006, 07:50 PM | #6 |
Junior member
Join Date: July 9, 2005
Posts: 369
|
Mine just pops right with ease.I too would contact Redding or maybe even who you bought it from they should take care of you.
|
January 31, 2006, 03:54 AM | #7 |
Member
Join Date: May 28, 2004
Location: Australia
Posts: 50
|
Sent it back for warranty repairs......best solution
thanks guys SB
__________________
Clean up your own mess |
January 31, 2006, 01:19 PM | #8 |
Senior Member
Join Date: February 29, 2000
Posts: 133
|
I just bought one and the shellholders (made by RCBS) popped right in.
|
|
|