July 30, 2011, 08:35 AM | #1 |
Member
Join Date: September 4, 2008
Location: Greenville, NC
Posts: 87
|
S&W M&P extractor
Okay I bought the Apex extractor but I cannot get the pin out that holds the extractor in the slide to remove the old one. I was told it should go out from top to bottom. When I try to tap it out all the pin punches start to bend.
I am stuck. Any body have any ideas. |
July 31, 2011, 02:20 PM | #2 |
Senior Member
Join Date: September 28, 2008
Posts: 10,442
|
Judging from this discussion on brianenos' forum, they are a terror to remove.
But here's how they did it. http://www.brianenos.com/forums/inde...&#entry1124761
__________________
Walt Kelly, alias Pogo, sez: “Don't take life so serious, son, it ain't nohow permanent.” |
August 1, 2011, 09:33 PM | #3 |
Member
Join Date: September 4, 2008
Location: Greenville, NC
Posts: 87
|
Thanks
|
|
|