The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > Handloading, Reloading, and Bullet Casting

Reply
 
Thread Tools Search this Thread
Old September 30, 2012, 12:17 AM   #1
mohr308
Senior Member
 
Join Date: January 15, 2012
Location: Western New York
Posts: 466
Running the expander ball back thru

Is it ok to run the expander ball back thru even though the cases have already been sized? I had been trimming cases and slightly bent a few necks at the very top, no other damage. I just don't want to load a bullet and have increased neck tension on a few rounds.
__________________
Lock and load, the zombies (democrats) are coming (to take your guns)!
mohr308 is offline  
Old September 30, 2012, 01:48 AM   #2
sidewindr
Senior Member
 
Join Date: June 4, 2011
Location: somewhere out there
Posts: 101
Yep,run it through to straighten them out,rather than using the bullet to do so.
sidewindr is offline  
Old September 30, 2012, 09:13 AM   #3
mohr308
Senior Member
 
Join Date: January 15, 2012
Location: Western New York
Posts: 466
Thanks!
__________________
Lock and load, the zombies (democrats) are coming (to take your guns)!
mohr308 is offline  
Reply

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 09:35 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2021 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Page generated in 0.05422 seconds with 10 queries