The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > Handloading, Reloading, and Bullet Casting

Reply
 
Thread Tools Search this Thread
Old January 20, 2012, 08:31 PM   #1
south.texas.dead.I
Senior Member
 
Join Date: February 5, 2011
Posts: 282
Loadmaster bullet feeder opinions

I'm thinking about getting a bullet feeder kit for my loadmaster. Anyone ever used it? Looking for opinions here it's for .40 s&w


Living another day
To bust another clay
south.texas.dead.I is offline  
Old January 21, 2012, 09:46 AM   #2
jmorris
Senior Member
 
Join Date: November 22, 2006
Posts: 3,076
It was the most useless Lee product I ever had. There are good bullet feeders out there, the Lee is not one of them.
jmorris is offline  
Old January 21, 2012, 11:24 AM   #3
south.texas.dead.I
Senior Member
 
Join Date: February 5, 2011
Posts: 282
So I take it you don't use yours then? Have you been having any of the parts break on you? Lee cs has been pretty good about replacing parts for me but I'm tired of emailing them and thinking about getting a couple spares of the weaker components. I've had the universal decapping pin snap on me twice I think, priming trough fail (replaced it with the newer Setup) and just recently found out the priming pin spring was bent up pretty good.


Living another day
To bust another clay
south.texas.dead.I is offline  
Reply

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 06:17 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2021 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Page generated in 0.03306 seconds with 8 queries