April 7, 2000, 09:19 PM | #1 |
Senior Member
Join Date: February 13, 2000
Location: MD
Posts: 566
|
I have a new SA 1911 - stainless, cocobolo grips. I've fired about 300 rounds through it. After removing the grip screws the grips will not come off on either side. I have tried gently prying with a knife between the grip and frame - no luck.
Any suggestions? |
April 7, 2000, 10:08 PM | #2 |
Staff Alumnus
Join Date: October 12, 1998
Location: Earlington KY
Posts: 2,299
|
Mike, take the handle of the knife, insert in the mag well and gently tap the grips from the inside. George
|
April 7, 2000, 10:58 PM | #3 |
Senior Member
Join Date: February 13, 2000
Location: MD
Posts: 566
|
George;
Thanks! That did it. There was a lot of crud under the grips. Mike |
|
|