|
Forum Rules | Firearms Safety | Firearms Photos | Links | Library | Lost Password | Email Changes |
Register | FAQ | Calendar | Search | Today's Posts | Mark Forums Read |
|
Thread Tools | Search this Thread |
April 25, 2007, 07:28 PM | #1 |
Senior Member
Join Date: April 23, 2007
Location: Pennsylvania, USA
Posts: 1,918
|
Help ID-ing Herretts grips
I'd recently picked-up a used set of Herretts shooting stars off of eBay. These are purportedly intended for a S&W K-Frame revolver. The seller had described them as ...SQUARE FRAME GRIPS THAT WILL FIT THE K FRAME TYPE MODEL 10 GUNS...
The grips' inletting is proportionally similar to my K38's grip, but a little too long and the cross section is a little too shallow. So the butt doesn't quite meet the base of the grip and the backstrap isn't flush. Also the mounting holes don't align with the K38's stock pin, it's ~1/4" forward of the hole provided. What's strange is that the label is for a Herrett's Model RNSS, which I've read designates the Ruger New Single Six?!? Any ideas? |
April 26, 2007, 10:18 AM | #2 |
Senior Member
Join Date: July 1, 1999
Location: Iowa
Posts: 2,135
|
Pop over to www.herrett-stocks.com or e-mail [email protected] to be sure, but I think your decoding of the part number sounds reasonable. Maybe the Speed Six model.
http://herrett-stocks.com/cshtstar.htm Joe
__________________
Go NRA |
April 26, 2007, 03:07 PM | #3 |
Senior Member
Join Date: April 23, 2007
Location: Pennsylvania, USA
Posts: 1,918
|
thanks for the tip, I've gotten the following...
... YOUR STOCKS SHOULD FIT A RUGER SECURITY SIX, NEW STYLE, SQUARE BUTT, OR POLICE SIX, SQUARE BUTT. HOPE THIS HELPS, IF CAN PROVIDE ANYTHING FURTHER LET ME KNOW. ... |
Thread Tools | Search this Thread |
|
|