January 25, 2013, 07:55 PM | #1 |
Senior Member
Join Date: November 25, 2012
Location: Indiana
Posts: 138
|
44mag with AA#7
Does anyone have any load data for a 200 grain Raineer flat point bullet with AA#7 powder for 44mag. I don't see anything for that bullet in my load data. I checked 200g jacketed data and they say start with 15.6g but that would be about 1270fps and I have always been told not to run plated bullets over 1200-1250 fps. Thanks for the help.
|
January 26, 2013, 05:57 AM | #2 |
Senior Member
Join Date: January 7, 2013
Location: hobart,in
Posts: 119
|
Have u looked on bear tooth bullets load swap section
|
January 26, 2013, 01:40 PM | #3 |
Senior Member
Join Date: January 7, 2013
Location: hobart,in
Posts: 119
|
rainier states if you have taditionally jacketed load data start in the mid load range
sorry didnt completely read the entire post i run the rainer hollow points in my 44mag rifle and am at mid range powder and they do fine no chrono on it yet. |
January 26, 2013, 09:35 PM | #4 |
Senior Member
Join Date: December 14, 2004
Location: Northern Indiana
Posts: 6,117
|
Accurate’s web site has loads for 7 for lead bullets your weight. Plated bullets should be run at the same max velocity as lead.
http://www.accuratepowder.com/wp-con...d_data_3.5.pdf
__________________
It was a sad day when I discovered my universal remote control did not in fact control the universe. Did you hear about the latest study.....5 out of 6 liberals say that Russian Roulette is safe. |
January 26, 2013, 09:37 PM | #5 |
Senior Member
Join Date: April 16, 2011
Location: Georgia
Posts: 1,599
|
It will use the same load as lead and I have used it with my .44mag on several occasions with cast bullets...worked very well.
|
|
|