The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > The Smithy

Reply
 
Thread Tools Search this Thread
Old May 16, 2005, 03:06 PM   #1
cptmclark
Senior Member
 
Join Date: November 22, 2004
Location: Indiana
Posts: 432
Armscor 1911 stainless barrel

Pistol came new with a bore that is much rougher than tool mark chatter could make, and only in spots. It is new. Sent it back and got it back without reply, except for a target marked 22 yards and about a 3" group. Not to expect greatness a bargain basement prices, I wonder if a drop in barrel would likely improve accuracy. The current set up locks up tightly and feels as good as my Gold Cup. Would "drop in" barrels mate with the Armscor clone?

Thanks
cptmclark is offline  
Old May 16, 2005, 04:03 PM   #2
Handy
Junior member
 
Join Date: August 31, 2001
Posts: 8,785
It sounds like your cheap, ugly barrel is an excellent match to your cheap 1911. Why break the Karma?

Once you buy a decent barrel (at least $130 with shipping) and have a gunsmith check the headspace and lockup you'll have spent the same amount as a low end Colt or a slightly improved SA. That's bad economics.

It works - shoot it. If you want better accuracy try a tighter bushing, first.
Handy is offline  
Reply

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 12:47 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2021 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Page generated in 0.03060 seconds with 8 queries