Winchester 1300 Defender sights

Powderman · August 19, 2013, 08:43 PM

Hi, everyone. I need some assistance....

A while back, I got a slug barrel for my Defender--20" with rifle sights. I intended to install it and use it with the shotgun--of course.

However, shortly after I fired the first rounds, I found that the rear sight was VERY loose in the dovetail. I re-installed the 18.5" riot barrel, and it's been there since. Here is my question: will the Tru-Glo rear sight fit the dovetail on the barrel---and can the front sight be easily replaced?

dwaawd · August 19, 2013, 10:14 PM

You may be able to tighten your rear sight by tapping it out and inserting a small screw driver into the sight and hitting it very lightly with a small ball peen hammer. That will spread the tangs downward a bit.

I have used the TruGlo slug gun optic front/rear sights on my 1300 Defender. They replace the factory sights with no problems. Part #TG961W.

Powderman · August 20, 2013, 12:52 AM

Thanks for the advice! I'll order a set.

August 19, 2013, 08:43 PM	#1
Powderman Senior Member Join Date: September 7, 2001 Location: Washington State Posts: 2,166	Winchester 1300 Defender sights Hi, everyone. I need some assistance.... A while back, I got a slug barrel for my Defender--20" with rifle sights. I intended to install it and use it with the shotgun--of course. However, shortly after I fired the first rounds, I found that the rear sight was VERY loose in the dovetail. I re-installed the 18.5" riot barrel, and it's been there since. Here is my question: will the Tru-Glo rear sight fit the dovetail on the barrel---and can the front sight be easily replaced? __________________ Hiding in plain sight...

August 20, 2013, 12:52 AM	#3
Powderman Senior Member Join Date: September 7, 2001 Location: Washington State Posts: 2,166	Thanks for the advice! I'll order a set. __________________ Hiding in plain sight...

August 19, 2013, 10:14 PM	#2
dwaawd Member Join Date: March 24, 2011 Location: Kalifornstan Posts: 73	You may be able to tighten your rear sight by tapping it out and inserting a small screw driver into the sight and hitting it very lightly with a small ball peen hammer. That will spread the tangs downward a bit. I have used the TruGlo slug gun optic front/rear sights on my 1300 Defender. They replace the factory sights with no problems. Part #TG961W.