February 17, 2005, 10:55 PM | #1 |
Junior Member
Join Date: February 17, 2005
Posts: 5
|
Favorite .357 load
Hey -- Just found this forum and this is my first post...
I've got a Desert Eagle .357, one of the original models, and I'm trying to find a good load for it. I've used 12.0 gr of Blue Dot with CCI small mag primers pushing a plated 125 gr flat point, with some success. It chrono'ed out with an average of 1451 and std dev of 33 -- a little higher than what I like. There were no signs of over pressure...the cases looked good and the primers weren't flat. I've got those bullets and I just picked up some 158 gr. TMJ's. But I'm always looking for a better load. So, any pet loads that you have I'd like to hear. Thanks 66gt350 |
February 18, 2005, 05:20 PM | #2 |
Member
Join Date: February 16, 2005
Location: Loogootee, Indiana
Posts: 36
|
I have used this load in a 10" TC Contender. Do not own a 357 mag barrel for it anymore though. This load is too hot for anything except Contender, Encore, Ruger Redhawh, and Ruger Blackhawk
19.5 grains 2400 behind a 125 grain JHP CCI mag primer. For Ruger Security 6 with 4" barrel I use same bullet & primer, but only 14 grains of powder |
February 18, 2005, 10:38 PM | #3 |
Senior Member
Join Date: June 21, 2002
Posts: 2,019
|
I like full charges of H110.
|
February 19, 2005, 05:13 AM | #4 |
Member
Join Date: January 31, 2005
Posts: 56
|
Anybody have a H110 or W296 load for the 180 grain bullets?
|
|
|