April 30, 2002, 06:43 PM | #1 |
Member
Join Date: April 1, 2002
Location: Peoples Demokratic Republik of Minnesota
Posts: 41
|
How to polish chamber?
I have a EAA Witness that has a rough chamber, I have already polished the feedramp, how do I polish the chamber?
Any suggestions would be greatly appreciated. Six. |
April 30, 2002, 11:21 PM | #2 |
Member In Memoriam
Join Date: March 17, 1999
Posts: 24,383
|
Cut a piece of 1/4" wooden dowel rod about 2-3 inches long and cut a slit in one end with a hacksaw. Then cut a 3/4" strip of #600 emery paper and put one end through the slot, wrapping the paper around the dowel, emery side out until it will just go in the chamber. Put the dowel rod in a drill and run it slowly for 10 seconds or so.
It may take 2 passes but shouldn't take more. (Maybe needless to say, but remove the barrel and work from the chamber end; one guy asked if what I recommended wouldn't hurt the rifling when he pushed the rod through the barrel to the chamber.) Jim |
May 1, 2002, 06:47 AM | #3 |
Senior Member
Join Date: February 20, 1999
Location: home on the range; Vermont (Caspian country)
Posts: 14,324
|
OR
Crocus cloth; less abrasive.
Remember the mantra "I can take more off but I CAN'T put it back....."
__________________
. "all my ammo is mostly retired factory ammo" |
Thread Tools | Search this Thread |
|
|