November 13, 2012, 10:55 AM | #1 |
Junior Member
Join Date: November 13, 2012
Posts: 3
|
Win 670
Anybody know where to get a trigger guard and screws for a Winchester 670, have exhausted all the usual parts houses, any suggestions will be appreciated.
|
November 13, 2012, 11:19 AM | #2 |
Senior Member
Join Date: June 20, 2007
Location: Rainbow City, Alabama
Posts: 7,167
|
The guard and screws from the same year Model 70 should also fit. The difference between the Model 70 and 670 was finish and stock quality.
|
November 13, 2012, 04:15 PM | #3 |
Junior Member
Join Date: November 13, 2012
Posts: 3
|
Thanks a million Doyle
|
November 13, 2012, 07:40 PM | #4 |
Senior Member
Join Date: September 16, 2009
Location: I live in the foot of the Green Mountains of Vermont
Posts: 1,602
|
The 670 has a blind magazine whereas most M70s are of the drop floorplate varity . Might be a good time to upgrade your 670 to bottom metal and an M70 stock !
|
November 14, 2012, 05:25 PM | #5 |
Senior Member
Join Date: September 19, 2008
Posts: 4,678
|
Actually, the issue M670 stock will accept the Model 70 TG w/floorplate, magazine liner, etc.
IIRC, the follower & spring you now have should fit/work OK. Just run a small drill(bit) down/out through all four corners of the blind magazine well, then cut out between the holes & clean up to get straight/tapering lines that match the M70 bottom metal. The bottom of the stock just ahead & behind the new magazine opening will also need to be inletted for the bottom metal. (I've added the upgrade to both Win 670's and old Rem 700 ADL's, both using new factory parts from the respective Parts Dept's) . |
November 14, 2012, 06:48 PM | #6 |
Senior Member
Join Date: June 15, 2008
Location: Georgia
Posts: 10,786
|
It won't be cheap, but you can contact these guys
http://williamsfirearms.com/triggerguard.html Found one here. http://www.gunpartscorp.com/Products/1296220.htm Last edited by jmr40; November 14, 2012 at 06:59 PM. |
Thread Tools | Search this Thread |
|
|