The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > Handloading, Reloading, and Bullet Casting

Reply
 
Thread Tools Search this Thread
Old January 29, 2007, 01:04 PM   #1
ECLIPSE45ACP
Senior Member
 
Join Date: January 9, 2007
Location: Omaha, NE
Posts: 177
? about lee turret press

Does it matter whether you have the standard turret or the classic turret, will the replacement heads fit in both? I was wondering because I ordered one and did not see anything specific regarding a different one for each, thanks.

Dan
ECLIPSE45ACP is offline  
Old January 29, 2007, 01:43 PM   #2
Rico567
Senior Member
 
Join Date: October 19, 2005
Posts: 162
I understand that the 4-hole turret fits both presses.
__________________
"Dear reader, suppose you are a member of Congress. Now, further suppose you are an idiot. But I repeat myself."

- Mark Twain
Rico567 is offline  
Old January 29, 2007, 07:22 PM   #3
amamnn
Senior Member
 
Join Date: May 13, 2006
Location: WA, the left armpit of the USA
Posts: 1,323
I upgraded to the classic and the turrets fit just fine. You will have to go through all the installation/adjustment procedures again for the dies, though.
__________________
"If the enemy is in range, so are you." - Infantry Journal
amamnn is offline  
Reply

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 08:08 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2021 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Page generated in 0.03574 seconds with 10 queries