|
Forum Rules | Firearms Safety | Firearms Photos | Links | Library | Lost Password | Email Changes |
Register | FAQ | Calendar | Search | Today's Posts | Mark Forums Read |
|
Thread Tools | Search this Thread |
February 15, 2012, 09:19 PM | #1 |
Senior Member
Join Date: January 21, 2012
Location: Sacramento
Posts: 125
|
Loading 357/38 with Power Pistol concern
I may be just a worrywart on this, but I'm somewhat new to reloading and want some confirmation (I load 40sw, 357 and 38). I've loaded some 357 and 38 special with power pistol, and off the bat, I'm having a really hard time visually confirming powder level with the tall revolver casings. So, to confirm the level I have to tilt the shell off of the carrier to see the powder (I'm also weighing every three or so rounds).
Here is my concern: Power pistol is not fluffy, but I'm going off of published load data. I can shake the rounds lightly and hear that there is a LOT of empty space in the cartridges. Is this okay??? I'm loading at near start load and know even max charges won't fill the cases. Loads listed below: 357 magnum 158 LSWC at .358" 7.5 gn of Power Pistol 38 special 158 LSWC at .358" 4.6 gn of Power Pistol Maybe time for a different selection of powder for my wheel gun?
__________________
”An unarmed man can only flee from evil, and evil is not overcome by fleeing from it.” ~Col. Jeff Cooper |
February 15, 2012, 09:26 PM | #2 |
Senior Member
Join Date: January 27, 2010
Location: Norfolk, VA
Posts: 2,905
|
The .38 was originally a black powder cartridge. Since black powder doesn't have near the energy per grain of modern powders, you used much more of it compared to modern loads. There will usually be quite a bit of empty space inside a .38/.357 cartridge, even with max loads.
My typical .38 load is 3.3 gr of W231 and a 148 gr DEWC bullet. I can fit four complete charges inside the case. Last edited by ScottRiqui; February 16, 2012 at 12:13 AM. |
February 15, 2012, 11:01 PM | #3 |
Senior Member
Join Date: May 13, 2006
Location: WA, the left armpit of the USA
Posts: 1,323
|
This may not be much help right now, but it might be at a later date--besides using a small flashlight to look in the case---if you have a digital scale--weigh the case before you drop the powder and zero the scale with the case on it. Then re-weigh with powder and the scale will give you your exact charge weight. If you really trust your powder measure, you need not do this for every case, but maybe 1 in 10. But if you get a big difference at case # 50, you would be wise to go back and check # 41 through 49.
The entire point is moot if you use a slower powder like HS-6 or N-340 and such. Also the chances of double charging a case are reduced if not eliminated by using a slower powder that fills the case better, to say nothing about better performance. I like Hodgon's Lil Gun for all my magnum pistol loads--partly for the way it fills up the case and partly because I get good accuracy and power with it. A slower powder can result in an increase in perceived recoil, which in the .38 special is not really a problem, but the .357 mag can be a bit much for some more sensitive--maybe poetic--folks when using a slow powder..........
__________________
"If the enemy is in range, so are you." - Infantry Journal |
February 16, 2012, 12:11 AM | #4 |
Senior Member
Join Date: January 21, 2012
Location: Sacramento
Posts: 125
|
I rather like your use of "poetic", as it can relate to few few shooters that I am introducing to the shooting arena.
Lights are great and safety is good as far as weighing goes.... I think it's just me wanting to be %100 sure of my accuracy of what I'm reloading so I wont blow off my trigger finger (quite a multi-tool). Different powder definitely needs to be explored, as I was "aiming" towards a multi-caliber powder to offset costs.
__________________
”An unarmed man can only flee from evil, and evil is not overcome by fleeing from it.” ~Col. Jeff Cooper |
February 16, 2012, 10:18 AM | #5 |
Senior Member
Join Date: March 31, 2011
Location: central Wisconsin
Posts: 440
|
In the long run you really are not saving money by buying one powder to do all/most of your calibers with.Certain ones you can but others it just doesn't pay, to a point. No matter what powder you use, you still have to pay for the it, so why not have one of the best performing for that particular cal.
__________________
sent via telegram |
February 16, 2012, 10:36 AM | #6 |
Senior Member
Join Date: November 9, 2008
Location: Hoschton, Ga.
Posts: 726
|
I installed a nice strip light on my reloading bench recently for that very issue.
__________________
Nov 2, 2011 sent form 4, SS Sparrow. Arrived May 29, 2012. Jan 30, 2012 sent form 1 for SBR. Arrived July 12, 2012 Jan 22, 2013 Sent form 4, 762-SDN-6. Arrived Sept 13, 2013 |
February 16, 2012, 11:17 AM | #7 |
Senior Member
Join Date: September 26, 2005
Posts: 941
|
A lot of good comments so far. About the only thing I'd add is that you might want to intentionally double-charge a case just so you know what it looks like and have a visual reference for comparison. Just be certain to immediately dump the powder from that case when you're done comparing so you don't inadvertently seat a bullet on it!
I'd also recommend a different powder for standard pressure .38 loads. For +P loads, Power Pistol would probably do well (I haven't tried it, but my favorite midrange .357 load uses PP), but for standard pressure you'll probably be happier with a slightly faster burning powder like 231, or even faster still (Bullseye, Clays, etc.) |
February 16, 2012, 01:12 PM | #8 |
Senior Member
Join Date: March 31, 2011
Location: central Wisconsin
Posts: 440
|
This is also where a powder check die comes in handy,for double checking only.
__________________
sent via telegram |
February 16, 2012, 01:25 PM | #9 | |
Senior Member
Join Date: August 7, 2010
Location: Northern, UT
Posts: 1,162
|
Quote:
I was going to suggest this as well. I use AA#5 (anti-fluffy as well) with some light .357 loads. "Case fill, what's that?" Even with that, a double charge is quite noticeable. Perhaps an inspection mirror w/ a light would help the process. I seem to recall reading somewhere that a guy rigged a mirror & light setup on his press. It may or may not be practical for everyone, but it might be worth investigating.
__________________
Cheers, Greg “At the core of liberalism is the spoiled child – miserable, as all spoiled children are, unsatisfied, demanding, ill-disciplined, despotic and useless. Liberalism is a philosophy of sniveling brats.” — P.J. O’Rourke |
|
February 17, 2012, 02:41 AM | #10 |
Senior Member
Join Date: January 21, 2012
Location: Sacramento
Posts: 125
|
I thank you for all of the very useful input. I've double charged a few times (with no bullets on my bench) to see if I could identify one but it seems that is still not even visible. What mid range load are you using for 357 with PP??
The mirror trick.... Now that is something to look into!
__________________
”An unarmed man can only flee from evil, and evil is not overcome by fleeing from it.” ~Col. Jeff Cooper |
February 17, 2012, 11:30 AM | #11 | |
Senior Member
Join Date: September 26, 2005
Posts: 941
|
Quote:
|
|
Thread Tools | Search this Thread |
|
|