June 30, 2008, 12:08 AM | #1 |
Senior Member
Join Date: September 9, 2005
Location: Ohio
Posts: 492
|
Ruger sight
I have a Ruger P-94. I want to put a new rear sight on it. I gave the old sight a couple of pretty good whacks. (yes I took the set screw out) Puppy would not budge. Anyone know any tricks?
|
June 30, 2008, 06:18 AM | #2 |
Senior Member
Join Date: August 17, 2007
Location: Georgia
Posts: 125
|
Rear sight
Take a brass punch, and hammer, and tap the sight to get it to move! Be careful, because there is a Firing pin block plunger that protrudes through an opening under the sight, and it is under spring pressure, so don't lose it You may have to tap it pretty hard, if it is really stuck, and also try tapping from right to left. Also you may try some WD-40 on it prior to tapping.
|
|
|