December 1, 2011, 05:18 PM | #1 |
Junior Member
Join Date: November 24, 2011
Posts: 8
|
Lathe Verses Case Trimmer
I am Totally new to Reloading and just recently Purchased a reloading press Kit.
It did not include a case trimmer. But I do Have a small Taig Lathe. Does anyone here prepare there Brass cases on a lathe instead of a trimmer? If so what cutter heads, Uniformers, and all the other attachements would you get to be able to prepare the cases on a lathe? Primarily starting out with 223 rem for single shot break open rifle. |
December 2, 2011, 12:28 PM | #2 |
Senior Member
Join Date: September 15, 2009
Location: Phoenix, AZ. 30 miles from water, two feet from Hell.
Posts: 355
|
E- mail me for some of my pictures.
I use nothing but a lathe for brass prep. Small bench top or the type Enco sells are great and have a lot of uses. Edward5759
__________________
Failure is part of success! This year will go down in history. For the first time, a civilized nation has full gun registration. Our streets will be safer, our police more efficient, and the world will follow our lead into the future!" -Adolf Hitler,1935" |
December 2, 2011, 04:56 PM | #3 |
Junior Member
Join Date: November 24, 2011
Posts: 8
|
I can't find your address in the info. If you would like just send the photos to [email protected]
Thanks |
Thread Tools | Search this Thread |
|
|