Browning Challenger 2 Feed Problem

prickett · August 5, 2000, 08:16 PM

I'm having a problem with my Challenger 2 not feeding reliably. After some investigation, I found the firing pin is forward when the bullet is being chambered. This changes the angle of the bullet, resulting in a jam. My question is... how do I remove the firing pin (so I can check for a damaged pin or clean it up)? I see the retaining pin, but it doesn't seem to want to move either direction. Is there a secret someone could clue me in to?

Thanks in advance.
Todd

George Stringer · August 6, 2000, 07:57 AM

Prickett, no trick just hit it a little harder I guess. George

August 5, 2000, 08:16 PM	#1
prickett Junior Member Join Date: July 22, 2000 Location: cincinnati, oh, usa Posts: 3	I'm having a problem with my Challenger 2 not feeding reliably. After some investigation, I found the firing pin is forward when the bullet is being chambered. This changes the angle of the bullet, resulting in a jam. My question is... how do I remove the firing pin (so I can check for a damaged pin or clean it up)? I see the retaining pin, but it doesn't seem to want to move either direction. Is there a secret someone could clue me in to? Thanks in advance. Todd

August 6, 2000, 07:57 AM	#2
George Stringer Staff Alumnus Join Date: October 12, 1998 Location: Earlington KY Posts: 2,299	Prickett, no trick just hit it a little harder I guess. George