|
Forum Rules | Firearms Safety | Firearms Photos | Links | Library | Lost Password | Email Changes |
Register | FAQ | Calendar | Search | Today's Posts | Mark Forums Read |
|
Thread Tools | Search this Thread |
September 12, 2011, 12:05 PM | #26 |
Senior Member
Join Date: December 29, 2004
Posts: 3,351
|
You need to keep in mind that what is done on a production basis requires repeatability and consistency in the final product, and often a strictly defined and required degree of hardening.
What can be accomplished with hand work for hardening (like 'spot hardening') is not going to be as consistent in the final outcome, but still may be adequate for the intended application. |
September 12, 2011, 01:17 PM | #27 |
Senior Member
Join Date: July 15, 2006
Location: Fern Creek ,KY and Metro Louisville at large
Posts: 430
|
Ok no problem
As posted by others I think a total heat treat with draw over pin holes Only problem is to do that right needs holding fixture and a oven. Your best bet would be to harden rails and spot treat pin holes with a torch and bucket of quenching oul
__________________
Republic Arms and Armaments 07 1-502-231-1118 Machine Shop and Finishing Services to the trade and public |
Thread Tools | Search this Thread |
|
|