|
|
|||||||
| Forum Rules | Firearms Safety | Firearms Photos | Links | Library | Lost Password | Email Changes |
| Register | FAQ | Calendar | Search | Today's Posts | Mark Forums Read |
 |
|
|
Thread Tools | Search this Thread |
September 1, 2000, 01:12 PM
|
#1 |
|
Senior Member
Join Date: July 26, 1999
Location: Georgia
Posts: 362
|
In case you didn't read my other post about SBH sights, my dad's Old Model SBH has a messed up rear sight. Ruger's customer service was slightly less than helpful so I looked up the rear sight assembly in Brownell's. They list 2 sights for the SBH: one "with bump" and one "without bump"--both for the same price. What is the "bump" and how can I determine whether or not he needs the "bump"?
Thanks again Jack [This message has been edited by Jack Straw (edited September 01, 2000).] |
|
|
September 2, 2000, 07:09 AM
|
#2 |
|
Staff Alumnus
Join Date: October 12, 1998
Location: Earlington KY
Posts: 2,299
|
Jack, remove the old sight and look at the bottom. That's were the bump is or isn't. George
|
|
|
|
September 5, 2000, 09:39 AM
|
#3 |
|
Senior Member
Join Date: July 26, 1999
Location: Georgia
Posts: 362
|
Thanks George.
Will do tonight. Jack |
|
|
|
September 5, 2000, 08:05 PM
|
#4 |
|
Senior Member
Join Date: January 30, 2000
Posts: 145
|
ruger rear sights are JUNK the only complaint I have with ruger the Millet or Smith enterprizes are all steel and great only one pin to push out......
|
|
|
|
| Thread Tools | Search this Thread |
|
|
