FS 1858 Remmy 45 LC conversion

tatso7 · December 6, 2009, 12:43 PM

Cleaning up the cabinet and need to let go some of the treasures. I fired this gun only ten times with 45 LC cowboy, cleaned, oiled and stored. I have a similar setup in stainless steel so this one has to go. The smeared like appearance on the gun surface is due to the oil reflection.

1858 Remmy ( no BP cylinder )
45 LC conversion cylinder
Slim Jim Holster
Belt.

To your door for $415. Thank you.

tatso7 · December 6, 2009, 12:45 PM

more photos...

ClemBert · December 6, 2009, 02:19 PM

Hate to be a Scrooge but don't let that FFL transfer requirement bite you. This appears to be a class 1 firearm and not a cap-n-ball revolver so "your door" may in fact be "your FFL dealer's door".

long rider · December 6, 2009, 03:04 PM

tatso put it on the buy and sell forum.

noelf2 · December 6, 2009, 09:10 PM

Clembert is right. Make sure you follow your state and the federal requirements with this revolver. This is no longer a C&B revolver unless you can find a C&B cylinder for it (or perhaps just don't sell it with the conversion cylinder in it). Sell that R&D cylinder separate, even if you sell it to the same buyer.

tatso7 · December 7, 2009, 11:25 AM

Clembert and Noelf2 - Thanks for the advice. You guys are right. I will have to rephrase the contents of my ad.

Long Rider - I intended to post this at the ad section. For some reason it ends up here.

Moderator - Please delete this thread. I will repost this at the appropriate section after revision of its contents. Thank you.

December 6, 2009, 03:04 PM	#4
long rider Senior Member Join Date: January 8, 2008 Posts: 669	tatso put it on the buy and sell forum. __________________ Sod Buster Tried To Pull On Willson.

December 6, 2009, 09:10 PM	#5
noelf2 Senior Member Join Date: April 14, 2008 Location: Stuart, VA Posts: 2,473	Clembert is right. Make sure you follow your state and the federal requirements with this revolver. This is no longer a C&B revolver unless you can find a C&B cylinder for it (or perhaps just don't sell it with the conversion cylinder in it). Sell that R&D cylinder separate, even if you sell it to the same buyer. __________________ Liberty and freedom often offends those who understand neither.

December 6, 2009, 02:19 PM	#3
ClemBert Senior Member Join Date: March 2, 2009 Location: Orlando Posts: 936	Hate to be a Scrooge but don't let that FFL transfer requirement bite you. This appears to be a class 1 firearm and not a cap-n-ball revolver so "your door" may in fact be "your FFL dealer's door".

December 7, 2009, 11:25 AM	#6
tatso7 Senior Member Join Date: March 22, 2006 Location: southwest Posts: 107	Clembert and Noelf2 - Thanks for the advice. You guys are right. I will have to rephrase the contents of my ad. Long Rider - I intended to post this at the ad section. For some reason it ends up here. Moderator - Please delete this thread. I will repost this at the appropriate section after revision of its contents. Thank you.