October 6, 2001, 09:47 AM | #1 |
Member
Join Date: April 14, 2000
Location: Sumrall, MS
Posts: 48
|
Remington 1100
Harley, I just bought a used Remington 1100 in 20 gauge and need instructions to detail strip. Can you help me?
My new emailaddress is: [email protected] Sid K |
October 6, 2001, 10:01 AM | #2 |
Senior Member
Join Date: April 6, 2000
Location: PA
Posts: 3,451
|
I have one of those too.
1. Lock the bolt open, and check for any rounds in the magazine while you're there. 2. Unscrew the magazine cap. 3. Remove the foreend and barrel forward to the front. 4. Remove the rubber gas seal ring to the front. 5. Remove the gas piston and the piston seal ring to the front. 6. Press the bolt latch and ease the bolt closed. 7. Push out the two large cross pins on the receiver. 8. Remove the trigger group, rotating it from the rear of the gun. You can continue to disassemble from here, but I usually just hose it down with gun scrubber, then lub everything and reassemble. |
October 7, 2001, 04:32 AM | #3 |
Staff In Memoriam
Join Date: January 8, 1999
Location: Brunswick,GA USA
Posts: 1,884
|
sid K
I have sent, by separate email, the assem/disassem w/photos, as they say in the Artillary, "on the way, wait" HJN |
October 8, 2001, 12:17 PM | #4 |
Senior Member
Join Date: March 30, 2000
Posts: 678
|
Hey, Harley! Send them to me, too!
__________________
"...where the wind comes sweeping down the plains..." |
Thread Tools | Search this Thread |
|
|