The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > Handloading, Reloading, and Bullet Casting

Reply
 
Thread Tools Search this Thread
Old February 16, 2000, 09:39 PM   #1
HKMP5SD6
Member
 
Join Date: February 15, 2000
Posts: 26
Has anyone here used an mp5 series weapon? My question is, when you release the magazine pushing the magazine release thingie, does it fall out or do you have to pull it out? Stupid question..........I'm a newbie.

------------------
"You can run, but you'll just die tired"
HKMP5SD6 is offline  
Old February 16, 2000, 10:41 PM   #2
Mal H
Staff
 
Join Date: March 20, 1999
Location: Somewhere in the woods of Northern Virginia
Posts: 16,947
You will most likely get a better answer if you post this question in the Full Auto forum instead of here in Handloading.
Mal H is offline  
Old February 17, 2000, 08:00 AM   #3
JMC
Senior Member
 
Join Date: March 6, 1999
Location: FL
Posts: 809
When using the magazine release, either the M-16 type button or paddle, a magazine will fall free of the weapon if there are rounds left in the mag and the weapon is held upright.

An empty mag may or may not fall free depending on several factors such as wear on the mag, dirt in the mag well...

------------------
Did you ever stop to think...
And then forget to start over again?


Jim - NRA Life Member

www.geocities.com/Heartland/Lake/3887/home.html
JMC is offline  
Old February 17, 2000, 02:01 PM   #4
LongDuck
Member
 
Join Date: September 15, 1999
Posts: 97
Having fired an MP5-A4 full-auto and burst, I can honestly tell you that the owner will not allow you find out at the range.

At $80-$100 in 'investment' per 30-round magazine, you will not be dropping these in the dirt to perform 'tactical-reloads' - at least, not for long.

The proper way to remove a mag from an MP5 is to grip the magazine with your off-hand, flap the lever and pull down while holding the lever in the forward position. This ensures positive control of the magazine and weapon at all times.
LongDuck is offline  
Reply

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 03:58 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2021 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Page generated in 0.05831 seconds with 10 queries