|
Forum Rules | Firearms Safety | Firearms Photos | Links | Library | Lost Password | Email Changes |
Register | FAQ | Calendar | Today's Posts | Search |
|
Thread Tools | Search this Thread |
June 10, 1999, 01:23 PM | #1 |
Junior Member
Join Date: May 31, 1999
Posts: 10
|
I’m looking for a set of carbide dies for .400 CorBon. I know Tombstone used to make them prior to going out of business. Anybody know where I can find a set?
Thanks, Sean |
June 10, 1999, 06:02 PM | #2 |
Staff
Join Date: March 20, 1999
Location: Somewhere in the woods of Northern Virginia
Posts: 16,950
|
Sorry, the ones I've seen are steel only, no carbide or Ti_Nitride. I'm not sure why.
|
June 10, 1999, 10:30 PM | #3 |
Senior Member
Join Date: October 9, 1998
Location: Black Hills of S. Dakota
Posts: 372
|
Sean,
At one time Tombstone made a set of carbide dies but unfortunately no longer. They were expensive too. I've been using Redding dies since 400 C-B was introduced. Even bought a Corbin cannalure tool but it's really not needed if you get a good solid crimp with your dies. (The Redding do an outstanding job there too). Bottom line is that Mal H is spot on... no carbide dies available new. -=[Bob]=- |
|
|