September 13, 2002, 07:09 PM | #1 |
Senior Member
Join Date: April 13, 2000
Location: bluefield
Posts: 735
|
pro 2000 ?
when i go from loading a short round to a longer round and then back my setting for my powder measure are not quite right.i have to move the height of the measure for the longer case.im only off a little does everybody else have the same problem.or can you go from a 40 s&w to a 44 mag and back to a 40 s&w without making an adjustment on your measure.when i first loaded 44 mag the measure was set for 510 after comming back to 44 later it had to be set for 480.not much but none would be better.im talking about moving the powder measure to allow for the longer case,thanks,keith
__________________
It's not just a gun it's the symbol of freedom |
September 13, 2002, 09:59 PM | #2 |
Senior Member
Join Date: July 31, 2000
Location: Middle Peninsula, VA
Posts: 1,588
|
I don’t see a way to avoid changing the height of the measure when going from one cartridge to another. However, it does not have anything at all to do with the setting of the charge weight. Maybe I’m misunderstanding the question.
For what it’s worth, when I go from 38 special to 45 ACP, I have to turn the measure in about three complete turns to get it set to the right height. |
September 14, 2002, 06:18 AM | #3 |
Senior Member
Join Date: April 13, 2000
Location: bluefield
Posts: 735
|
i had to take a spacer out of the measure.if i rember right i had to put it there because the 357 sig was so short.it sounds like i might not have to next time.if i have the right combo set up,thanks,keith
__________________
It's not just a gun it's the symbol of freedom |
September 14, 2002, 06:20 AM | #4 |
Senior Member
Join Date: April 13, 2000
Location: bluefield
Posts: 735
|
the way i had it set if i turned it enough to let me load the 44 it came unscrewed all the way,thanks,keith
__________________
It's not just a gun it's the symbol of freedom |
|
|