|
March 14, 2010, 03:20 PM
|
#1 |
|
Senior Member
Join Date: April 13, 2005
Location: No Where Good!
Posts: 103
|
SIG P226 - Not working
I have a DA/SA P226 that stop working last time at the range. In double action mode - the trigger cocks and releases the hammer, BUT the hammer does not fall forward enough to hit the firing pin.
When in single action mode - the trigger bar does not engage the sear (hammer does not fall) and the trigger bar moves freely. I took the gun apart to see if any parts were broken or missing, but everything "seems" to be OK. What could the problem be? thanks in advance.
__________________
"A gun isn't a weapon, it's a tool... like a butcher knife, or a harpoon or... or... an alligator!" - Homer Simpson Sight Alignment, Trigger Squeeze. |
|
|
March 14, 2010, 03:52 PM
|
#2 |
|
Member
Join Date: March 13, 2009
Posts: 44
|
Sounds like the trigger bar may be worn where it does not disengage the firing pin safety.
|
|
|
|
March 16, 2010, 08:21 PM
|
#3 |
|
Senior Member
Join Date: April 13, 2005
Location: No Where Good!
Posts: 103
|
i figured it out. It was a broken internal saftey lever.
__________________
"A gun isn't a weapon, it's a tool... like a butcher knife, or a harpoon or... or... an alligator!" - Homer Simpson Sight Alignment, Trigger Squeeze. |
|
|
 |
|
|
