Lee vs RCBS procedural steps - Page 2

Axelwik · May 24, 2012, 11:10 AM

Quote:

No. If the case would even enter the die, you would just be taking out the flare that you just put on.

I have never seen a die set with the decap rod in the flare die.

You sure about that one?

Sent from MIUI using Tapatalk 2.

I have an old RCBS pistol die set (.38/.357) with the decapper in the flaring die.

eldorendo · May 24, 2012, 01:48 PM

Fortunately, I guess I'm just not "most folks!"

I use primarily Lee dies with my Dillon 650 press. I don't own any Dillon dies. I do have some Redding dies in .40 Super, but don't load .40 Super anymore.

I doubt that "most folks" use the same brand dies as presses.

dacaur · May 24, 2012, 09:48 PM

I use lee dies with my lee press only becuase they are the best value. If another brand of dies offerd better value, I would use that.

May 24, 2012, 01:48 PM	#27
eldorendo Senior Member Join Date: May 8, 2012 Posts: 239	Fortunately, I guess I'm just not "most folks!" I use primarily Lee dies with my Dillon 650 press. I don't own any Dillon dies. I do have some Redding dies in .40 Super, but don't load .40 Super anymore. I doubt that "most folks" use the same brand dies as presses.

May 24, 2012, 09:48 PM	#28
dacaur Senior Member Join Date: March 16, 2010 Posts: 733	I use lee dies with my lee press only becuase they are the best value. If another brand of dies offerd better value, I would use that.