SP01 owners, a question

chris in va · November 14, 2012, 10:30 PM

Could you measure your factory rubber grips? I'd like to find out if they would fit my 97b, even with a slight gap toward the front.

cogito · November 15, 2012, 11:37 AM

Can you tell me what precisely you want measured? Length, top width, middle, bottom, etc?

They're not a regular polygon, so a few measurements would be needed.

chris in va · November 16, 2012, 01:14 AM

Mainly width and length. I think it might (sorta) fit on my 97b, just wondering how much gap I'll have to accept.

I fitted the factory plastic 75b grip on it and there was some 'daylight' showing from inside the frame toward the front strap.

Basically just trying to find grips with the 'coke bottle' profile. CZ in their infinite wisdom decided to make the grips flat on the 97.

cogito · November 16, 2012, 09:50 PM

Width across bevel at the top: 1"
Width across top flare: 1 3/8"
Width at screw: 1 1/2"
Width at CZ log: 1 1/2"
Width at very bottom: 1 3/8"

Length across mid-line of grip: 3 3/4"

Of course, I may be off a bit here and there, but the above should be within 1/8th of an inch, probably more like a 1/16 margin of error.

(SP-01, standard/base model)

chris in va · November 30, 2012, 12:21 AM

Thank you very much!

November 14, 2012, 10:30 PM	#1
chris in va Senior Member Join Date: December 26, 2004 Location: Louisville KY Posts: 13,806	SP01 owners, a question Could you measure your factory rubber grips? I'd like to find out if they would fit my 97b, even with a slight gap toward the front.

November 16, 2012, 01:14 AM	#3
chris in va Senior Member Join Date: December 26, 2004 Location: Louisville KY Posts: 13,806	Mainly width and length. I think it might (sorta) fit on my 97b, just wondering how much gap I'll have to accept. I fitted the factory plastic 75b grip on it and there was some 'daylight' showing from inside the frame toward the front strap. Basically just trying to find grips with the 'coke bottle' profile. CZ in their infinite wisdom decided to make the grips flat on the 97. Last edited by chris in va; November 16, 2012 at 01:24 AM.

November 15, 2012, 11:37 AM	#2
cogito Member Join Date: October 16, 2012 Location: Mid-Western State Posts: 37	Can you tell me what precisely you want measured? Length, top width, middle, bottom, etc? They're not a regular polygon, so a few measurements would be needed.

November 16, 2012, 09:50 PM	#4
cogito Member Join Date: October 16, 2012 Location: Mid-Western State Posts: 37	Width across bevel at the top: 1" Width across top flare: 1 3/8" Width at screw: 1 1/2" Width at CZ log: 1 1/2" Width at very bottom: 1 3/8" Length across mid-line of grip: 3 3/4" Of course, I may be off a bit here and there, but the above should be within 1/8th of an inch, probably more like a 1/16 margin of error. (SP-01, standard/base model)

November 30, 2012, 12:21 AM	#5
chris in va Senior Member Join Date: December 26, 2004 Location: Louisville KY Posts: 13,806	Thank you very much!