|
Forum Rules | Firearms Safety | Firearms Photos | Links | Library | Lost Password | Email Changes |
Register | FAQ | Calendar | Search | Today's Posts | Mark Forums Read |
|
Thread Tools | Search this Thread |
September 19, 2002, 09:18 PM | #1 |
Senior Member
Join Date: December 24, 2001
Location: Peoples Republik of Maryland, Sister State to Kalifornia
Posts: 619
|
10/22 extended magazine release switch???
How exactly does a guy install one of those 4 dollar extended magazine release tabs on a 10/22 (factory)?
Are there any online illustrated instructions? ( i can't find any) Please help us out! C-
__________________
___________________________ "Necessity is the plea for every infringement of human freedom. It is the argument of tyrants; it is the creed of slaves." -- William Pitt (1783) |
September 19, 2002, 09:31 PM | #2 |
Senior Member
Join Date: February 23, 2000
Location: California USA
Posts: 4,533
|
Knock out a pin with a punch
There's just a pin holding it in, and the pin only holds one other thing in place (bolt hold-open).
The easiest way is to use a piece of dowel or similar to keep the place of the pin as you install the part. This "slave pin" will hold the other part in place while you install the mag release. Check out WWW.rimfirecentral.com for more info. Regards. |
Thread Tools | Search this Thread |
|
|