The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > Handloading, Reloading, and Bullet Casting

Reply
 
Thread Tools Search this Thread
Old April 22, 2009, 11:25 AM   #1
M14MSgt
Senior Member
 
Join Date: August 11, 2007
Location: Lancaster CA
Posts: 105
Rim Rock Bullets

Anyone have any experience with their products? http://www.rimrockbullets.net/catalog/
M14MSgt is offline  
Old April 22, 2009, 07:25 PM   #2
tiberius10721
Junior member
 
Join Date: December 22, 2008
Posts: 228
Roze distributing is better!

Last edited by tiberius10721; April 22, 2009 at 07:37 PM.
tiberius10721 is offline  
Old April 23, 2009, 06:12 AM   #3
iblong
Senior Member
 
Join Date: October 1, 2008
Location: MN
Posts: 559
I can only speak about there 158gr LSWC HP 38/357 bullets,They are very soft lead,with a gas check.These are the Bullets that B.Bore uses in there
GC 158gr lswc hp +p and standard pressure loads.I like them a lot and they shoot well out of all 3 of my revolvers.I use these for my low +p loadings and do not seam to have any leading problems.FBI load.
Bob.

Last edited by iblong; April 23, 2009 at 06:14 AM. Reason: Spelling go figure
iblong is offline  
Reply


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 04:09 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2021 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Page generated in 0.04506 seconds with 10 queries