May 23, 2013, 06:55 PM | #1 |
Junior Member
Join Date: May 5, 2013
Location: South Lyon Mi
Posts: 4
|
Baikal shotgun
Has anybody got some ideas on polishing shotgun chambers for CAS for fast emptying that work?
|
May 23, 2013, 10:08 PM | #2 |
Senior Member
Join Date: June 2, 2009
Posts: 438
|
I used some really fine sand paper with a little oil.
Steel wool may work too. |
May 24, 2013, 07:33 PM | #3 |
Senior Member
Join Date: January 29, 2005
Location: Southern California
Posts: 344
|
I have used steel wool on two guns and so far it worked well for me. Took a couple of hours but I had the time.
|
May 24, 2013, 08:39 PM | #4 |
Senior Member
Join Date: February 24, 2013
Posts: 583
|
I took a high brass empty cleaned the hull out of it. drilled out the primer for a 1/4 inch bolt found a dowel the right size, sawed a slot in it and epoxied all together. Cut wet-dry emery paper to fit and wrap around dowel. I started with 320 then 600 finished with 1500
I turned it with a cordless drill,changing directions, and spraying kerosene. I don't think you could get a better honing with en expensive store-bought hone, but it took a while. |
May 25, 2013, 06:34 PM | #5 |
Junior Member
Join Date: May 5, 2013
Location: South Lyon Mi
Posts: 4
|
Thanks for the ideas
|
May 25, 2013, 07:00 PM | #6 |
Senior Member
Join Date: September 8, 2007
Location: Mississippi
Posts: 16,177
|
+1 on the emory cloth and dowel.
|
Thread Tools | Search this Thread |
|
|