The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > The Smithy

Reply
 
Thread Tools Search this Thread
Old February 3, 2001, 09:01 PM   #1
ChrisMkIV
Senior Member
 
Join Date: April 15, 2000
Location: The Colony,Tx
Posts: 338
I owned a Colt National Match with a 4-star aluminum comp., I bought it thru mail order and had my gun smith install it.

It did add lenth to my barrel, but I noticed very little balance changes, so it was a good improvement. My .45 now shot with the recoil of a light load small round.

Then I saw how you could send your gun off to get the comp milled right into your guns frame. and the cost was much higher, is this type of comp. worth the money? and what kind of impact does the cut do to the frame's design?
__________________
"Arms discourage and keep the invader and plunderer in awe, and preserve order in the world as well as property...Horrid mischief would ensue were the law abiding deprived the use of them" --Thomas Paine, 1775

Second Amendment Lovers HQ
Texas Tyranny Response Team
ChrisMkIV is offline  
Reply


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 12:59 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2021 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Page generated in 0.04201 seconds with 8 queries