October 6, 2013, 06:26 PM | #1 |
Senior Member
Join Date: May 29, 2007
Posts: 118
|
Weatherby Model 82
have a weatherby model 82 12 gauge wont eject fired shells any ideas whats wrong. I am just asking for suggestions about what to check first i have allready cleaned it real well and lubed it. thanks for any ideas
|
October 6, 2013, 07:40 PM | #2 |
Senior Member
Join Date: September 19, 2008
Posts: 4,678
|
.
The first thing I would check is that the ejector moves freely in/out, in it's hole in the bolt face, and that it's coil spring hasn't collapsed or gone walkabout / broken. . |
October 6, 2013, 09:08 PM | #3 |
Senior Member
Join Date: May 29, 2007
Posts: 118
|
Will check this thank you
|
October 7, 2013, 05:15 AM | #4 |
Senior Member
Join Date: February 11, 2012
Location: Williamsburg, Va.
Posts: 1,528
|
Also check and make sure the bolt is coming all the way back when firing. Easiest way is to put a piece of masking tape on the receiver so the handle tears it.
__________________
What could have happened... did. |
October 7, 2013, 10:08 AM | #5 |
Senior Member
Join Date: September 19, 2008
Posts: 4,678
|
.
+1 - If the bolt's not being pulsed back far enough to eject the fired shell, it might be that the gas port(s) in the bottom of the bbl (inside the ring around the mag tube) are partially plugged. The port(s) are usually able to be cleaned out with a bent wire of the proper diameter. . |
October 7, 2013, 10:26 AM | #6 |
Junior member
Join Date: December 20, 2012
Location: The "Gunshine State"
Posts: 1,981
|
Might want to check out some of the offered solutions to a similar problem here:
http://www.shotgunworld.com/bbs/view...f=114&t=190505 and see if those might work for your problem |
|
|