The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > The Smithy

Reply
 
Thread Tools Search this Thread
Old July 7, 2007, 12:54 PM   #1
glockorama
Senior Member
 
Join Date: March 28, 1999
Location: WA
Posts: 515
CZ-82 tigger/sear problem

I recently recieved 2 82's from AIM. They are both in excellent condition, looking brand new.
Unfortunately, during the 1st range session, a few problems arose.
One gun had the now infamous missing slide release spring. Had it before shooting, lost it somewhere during. Have ordered a few new springs from Norm
Sutton, so, hopefully, that will be rectified soon.
The bigger head-scratcher is on pistol #2; it shot fine and dandy at the range (great shooting guns and quite accurate), however, after getting it home, the hammer does not always release when the trigger is pulled in DA. If I pull the DA trigger REALLY fast it usually trips the hammer, but if I pull it slowly, or even normally, the trigger will go fully to the rear, as will the hammer, but the hammer will not fall. If I release the trigger a bit forward, the hammer usually falls (but not at any time during the initial pull back). SA trigger releases just fine.

Any thoughts?
__________________
10mm; heavy, fast, and powerful, when only the best will do.
glockorama is offline  
Reply


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 07:20 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2021 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Page generated in 0.03510 seconds with 10 queries