The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > Handloading, Reloading, and Bullet Casting

Reply
 
Thread Tools Search this Thread
Old June 26, 2009, 07:46 PM   #1
vintagemc313
Member
 
Join Date: April 4, 2008
Posts: 33
Die interchange question

I have most of the dies that I will use when I try my hand at reloading. So, when I finally find some reasonable primers, I have a question about die interchange. I have a Lee single stage press. If I can find 9, 40, and 45 dies in any other name brand, are the threads the same, and will they work OK? Any brands that won't work? Thanks
vintagemc313 is offline  
Old June 26, 2009, 08:17 PM   #2
lee n. field
Senior Member
 
Join Date: October 12, 2002
Location: The same state as Mordor.
Posts: 5,564
The only things that won't work are dies for the Lyman 310 tong tool and dies for the Dillon Square Deal. And, of course, the Lee Loader, which is a completely different loading system.

Everything else will have the standard thread.
__________________
"As was the man of dust, so also are those who are of the dust, and as is the man of heaven, so also are those who are of heaven. Just as we have borne the image of the man of dust, we shall also bear the image of the man of heaven. "
lee n. field is offline  
Reply

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 05:22 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2021 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Page generated in 0.04670 seconds with 8 queries