The Firing Line Forums

Go Back   The Firing Line Forums > The North Corral > Curios and Relics

Reply
 
Thread Tools Search this Thread
Old December 24, 2012, 12:00 PM   #1
starkey6
Junior Member
 
Join Date: December 23, 2012
Posts: 1
any help

Looking for a pair of rubber grips for a iver johnson top break 38 s&w. Just wondering if they make them or did make them or even wood ones woud work.
starkey6 is offline  
Old December 24, 2012, 01:47 PM   #2
James K
Member In Memoriam
 
Join Date: March 17, 1999
Posts: 24,383
If you mean repros of the original grips, try www.gungrip.com

Jim
James K is offline  
Old December 25, 2012, 12:05 PM   #3
PetahW
Senior Member
 
Join Date: September 19, 2008
Posts: 4,678
Vintage grips has them, but there are three sizes for .38 cal IJ revolvers, and it depends whether you revolver is hammerless or an exposed hammer type - you need to measure your gun and compare those to the measurements for each of the three grips.

The screws are not included, but Vintage Grips has them if you order them also.

http://vintagegungrips.net/ivjopigr.html



http://vintagegungrips.net/ivjo38sw.html

Dimensions;
Measuring backside of right panel (vertical not diagonal) 2 17/32" long
1 1/8" wide across center of screw hole @ butt


http://vintagegungrips.net/ao-i2a.html

Dimensions / Sizes for the Iver Johnson .38 Break Top Revolver Grips.
Measuring right panel (vertical not diagonal)
2 7/16” @ longest point
1 1/8” wide across center of screw hole
1 5/32” wide across center of pin hole


http://vintagegungrips.net/ao-i2.html

Iver Johnson .38 Brk Top Rev. w/Hammer
Measuring back side of right panel (vertical not diagonal)
2 ½” long
1 1/32” between “ears” – tip to tip
1 1/8” wide across center of pin hole


.
PetahW is offline  
Reply

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 04:21 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2021 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Page generated in 0.03510 seconds with 8 queries