|
Forum Rules | Firearms Safety | Firearms Photos | Links | Library | Lost Password | Email Changes |
Register | FAQ | Calendar | Today's Posts | Search |
|
Thread Tools | Search this Thread |
April 26, 2010, 06:11 PM | #1 |
Junior Member
Join Date: April 26, 2010
Posts: 1
|
Stevens 22/410 Help Needed
Can anyone provide me instructions on how to replace the barrel selector, button and screw on an old Stevens Model 22/410? Any help would be sincerely appreciated.
|
April 26, 2010, 06:22 PM | #2 |
Senior Member
Join Date: April 6, 2007
Posts: 2,568
|
Sounds like some work you might want a smith to do...
__________________
Math>Grammar |
April 26, 2010, 07:17 PM | #3 |
Senior Member
Join Date: September 19, 2008
Posts: 4,678
|
It's been almost 30 years since I've done one, and I'm too lazy to partially disassemble one of mine - but - IIRC :
Step one is, remove the barrels from the frame Two - remove the buttstock from the frame. Three, cock the hammer & pin the mainspring strut to relieve spring tension on the hammer. Four, remove the mainspring & drive out it's pivot pin to remove the hammer. * * * * * * * The side selector should now be accessable for switching out if a replacement in on hand. Reassemble in reverse order. (take 2 aspirin, call us in the morning ) If the "replacement" selector is actually a new hammer with the selector in it's pivoting nose, simply reinstall the hammer/mainspring, using the new hammer after first removing/discarding the broken side selector parts. (they are irrepairable, believe me when I tell you this) Re-install the buttstock, and cover the side button hole with a dime (epoxy), or whatever. . Last edited by PetahW; April 26, 2010 at 07:23 PM. |
|
|