|
Forum Rules | Firearms Safety | Firearms Photos | Links | Library | Lost Password | Email Changes |
Register | FAQ | Calendar | Today's Posts | Search |
|
Thread Tools | Search this Thread |
November 12, 2012, 08:07 PM | #1 |
Member
Join Date: April 6, 2011
Posts: 23
|
Hornady 165gr SST.......no exit wound.
Hope this is the right sub-forum to post this on but anyway here goes......
Shot a small doe last night. Good hit, behind and a couple inches low of the shoulder. She was about 85 yds out. I was shooting the above mentioned shell and I can't believe I didn't get an exit wound. Not really complaining, she dropped like rock, just can't believe that she'll would expand like that. Is this normal for that she'll or not? You guys know more than me about this sorta thing so I'm curious and thought I would ask. I was using my Browning 30.06 btw. Thanks |
November 12, 2012, 08:18 PM | #2 |
Senior Member
Join Date: October 19, 2005
Location: Tx Panhandle Territory
Posts: 4,159
|
Yeah, I believe that. I was searching for 165gr pills for my M1 and M1A, thinking of sticking to lower velocities. Anyway, I did a lot of digging on the innerwebs and that's the general consensus of folks who use them. The idea I formed was that they would be a great varmint round... if the nation was to get itself all plagued with 120lb+ varmints.
__________________
Rednecks... Keeping the woods critter-free since March 2, 1836. (TX Independence Day) I suspect a thing or two... because I've seen a thing or two. |
November 12, 2012, 09:43 PM | #3 |
Senior Member
Join Date: November 18, 2005
Location: On the Santa Fe Trail
Posts: 8,249
|
Yeah, I think that is typical for that bullet. From what I've read the SST isn't known for staying in one piece. If they do create an exit it is rather large usually. If you want a bullet that is going to exit stick to 180 grain bullets or a premium like the Partition or TSX.
When you dressed the doe out did you find any part of the bullet?
__________________
NRA Life Member |
November 13, 2012, 02:11 AM | #4 | |
Senior Member
Join Date: August 25, 2008
Location: In the valley above the plain
Posts: 13,424
|
Quote:
Even a 150 gr Partition is likely to exit, when the SST did not. And, a 180 gr SST is just as likely to grenade and not exit, as the 165 gr version. SSTs are designed to expand rapidly and quickly dump a lot of energy into the animal's tissue/organs, with no real intent to exit. Regardless of weight, the design is the same. "Controlled expansion" bullets like the Nosler Partition, Swift A-Frame, etc. are designed to open slowly and penetrate as far as possible. Regardless of weight, the design is the same. Construction, not weight.
__________________
Don't even try it. It's even worse than the internet would lead you to believe. |
|
November 13, 2012, 06:57 AM | #5 |
Staff in Memoriam
Join Date: November 13, 1998
Location: Terlingua, TX; Thomasville, GA
Posts: 24,798
|
"Construction, not weight."
Yup. Although, in general, a thirty-caliber 180 is of heavier construction than a 150. That showed in the crater depth on steel at my 500 yard range. An example from my own experience: The Sierra 150-grain SPBT will blow up if the impact velocity is at or above 3,000 ft/sec. The flat-base will not; it's of slightly heavier construction. |
November 13, 2012, 08:30 AM | #6 |
Senior Member
Join Date: June 20, 2007
Location: Rainbow City, Alabama
Posts: 7,167
|
That's the reason I absolutely refuse to use any SST bullet for hunting. I want the bullet to stay together and exit plus I don't want all the meat damage that an SST typically ruins.
|
November 13, 2012, 09:17 AM | #7 |
Senior Member
Join Date: May 11, 2011
Location: Colorado
Posts: 218
|
Years ago I tried several brands of bullets looking for the "perfect" recipe for my 308. 150 grain bullets shot best, so I went hunting. It took me several years, several different brands of bullets and several deer to find a bullet that left an exit hole. I ended up with the tried and true Nosler Partition. When I started elk hunting and was working up a load for a new rifle in 300 WSM, I went straight for the Partitions, this time in 180 grain.
|
November 13, 2012, 11:36 AM | #8 |
Member
Join Date: April 6, 2011
Posts: 23
|
Thanks a lot guys for the replies.
|
November 13, 2012, 04:32 PM | #9 | |
Senior Member
Join Date: November 18, 2005
Location: On the Santa Fe Trail
Posts: 8,249
|
Quote:
Most cup and core bullets work well with an impact velocity of 2800 fps down to 1800 fps or less. You can expect adequate penetration and damage in that window, but not always an exit. When comparing 150-180 .308 caliber bullets you'll have a higher percentage chance of more retained weight and pass through with the heavier bullet. Simply because it impacts with less velocity, even a thin jacketed bullet like the SST has a better chance of leaving an exit wound. At 85 yards a 165 grain bullet is still close to the upper limits of impact velocity for a cup and core bullet.
__________________
NRA Life Member |
|
November 13, 2012, 09:25 PM | #10 |
Member
Join Date: April 6, 2011
Posts: 23
|
Taylorco1...... Didn't find the bullet but didn't really look either. I don't gut deer, I just hang em up, skin em, debone all the meat and drag the carcass and guts off.
As far as the SST ruining meat, I had a entrance wound in the ribs and that was it. I usually don't mess with the rib meat anyway. So no meat ruined. FWIW. |
November 14, 2012, 05:11 PM | #11 | |
Senior Member
Join Date: September 19, 2008
Posts: 4,678
|
Quote:
. |
|
November 14, 2012, 05:21 PM | #12 | |
Member
Join Date: April 6, 2011
Posts: 23
|
Quote:
Make sure the first incision is not to deep or you will cut into the gut. |
|
November 14, 2012, 06:26 PM | #13 |
Senior Member
Join Date: June 15, 2008
Location: Georgia
Posts: 10,809
|
I quit gutting deer long ago. I'm often far from the road and it is a lot easier to just get the edible parts, put them in a pack and carry it out on your back. You will easily leave 1/2 the animals weight behind unless you are carrying the head and cape for a mount. It may take 2 trips if hunting solo, but it is much easier than gutting and dragging a carcass for miles in the mountains. Getting the tenderloins is easy and the 1st part taken.
Sounds like you used an a bullet designed for the game hunting and it worked as designed. Their are several difffeent bullet designs that react differently. Some kill by rapidly expanding, others expand less and penetrate more. All work if used on game they were designed for and applied correctly. |
November 14, 2012, 08:22 PM | #14 |
Junior member
Join Date: February 2, 2010
Posts: 6,846
|
I've experienced some bullet failures with both SST and Ballistic Tips. Most work as advertised albeit a little violent in certain presentations, but occasionally, there's the unexplainable blowup.
The specific bullets I'm using are Nosler 165 BT in 30/06 and Hornady 154 SST in hot loaded 7x57. Both have killed quite a few deer but maybe 1/5 shows some pretty violent expansion. |
November 15, 2012, 03:53 AM | #15 |
Senior Member
Join Date: October 9, 2009
Location: North Alabama
Posts: 8,309
|
SST's and BT's
I have never shot SST's, but the thin skinned, boat-tailed, polymer pointed SST seems in appearance anyhow, to be Hornady's version of the Nosler Balistic Tip (BT).
The BT was all the rage here for a while. From a 7mm Mag, the 140 BT was a virtual hand grenade. I do not get that kind of results from my 130/.270's, but I cannot drive them in excess of 3000 fips from my 22" ADL. Our deer average maybe 150 live for mature buck. Anything over 175 is a giant, and 200+ is all but unheard of. The slick, qick opening BT/SST clan do very well on our cretters. At least one name writer has declared the BT the ideal whitetail round. I'd think the SST is similar. |
November 15, 2012, 07:33 AM | #16 |
Senior Member
Join Date: June 11, 2007
Posts: 2,155
|
Hornady write upon the SST bullet they mention that it expands more quickly than their standard hunting bullet which it sound like it did.
If your getting bullet to expand like that may not get exit wound so can't say the SST didn't do what it was suppose to do. Sure be interesting if bullet was found and how much it weighted.
__________________
Semper Fi Vietnam 1965 VFW Life member NRA Life Member |
November 15, 2012, 02:15 PM | #17 | |
Member
Join Date: April 6, 2011
Posts: 23
|
Quote:
|
|
November 15, 2012, 02:21 PM | #18 | |
Member
Join Date: April 6, 2011
Posts: 23
|
Quote:
|
|
November 15, 2012, 02:25 PM | #19 | |
Member
Join Date: April 6, 2011
Posts: 23
|
Quote:
|
|
November 16, 2012, 12:42 AM | #20 |
Senior Member
Join Date: July 8, 2010
Location: North Georgia
Posts: 1,679
|
I use the SST's alot in 270 Win 130gr. & 25-06 in 117gr. Like you said you get alot of DRT kills & the range really doesent matter.Ive took them from 30yds. to 400yds pretty much with the same result. I almost never get alot of meat damage,stay off the shoulders they aint that bad.I think the SST's are a great hunting bullet used them for years. good luck this season.
|
November 16, 2012, 04:27 AM | #21 |
Member
Join Date: April 6, 2011
Posts: 23
|
Thanks Big P and same to you too. I think I'm gonna stay with the SSTs. If they expand that quickly and don't damage the meat on the opposite side then I'm gonna keep using em.
|
|
|