|
October 12, 2011, 11:12 PM
|
#1 |
|
Junior member
Join Date: October 6, 2010
Location: Michigan
Posts: 1,080
|
Hidden Powder?
Hello, guys. Just a heads up if your pulling bullets from loaded rounds.
I was pulling .22 Hornet loads..these were slightly compressed loads of H4227. Cases were being up-ended into original powder can..saw steady stream of powder run from each case. Then curious, I used a mag-light to peer into cases..there was powder in most of them!..Using a brazing rod, I loosened up & poured out another 2-4grs. of powder! Be careful out there! |
|
|
October 12, 2011, 11:36 PM
|
#2 |
|
Senior Member
Join Date: May 22, 2010
Location: North East WI
Posts: 418
|
Good heads up.
|
|
|
|
October 13, 2011, 12:40 AM
|
#3 |
|
Senior Member
Join Date: August 25, 2008
Location: In the valley above the plain
Posts: 13,424
|
When pulling down loads, give the cases a tap-tap-taparoo, on the edge of the powder catching device (garbage can, canister, bowl, whatever you're using).
Even uncompressed loads may have some stubborn powder 'deposits' hanging around. If you're going to be reloading the cases without further processing, be sure to visually check each case. (As IdealTool noticed... it isn't a bad idea, any way.)
__________________
Don't even try it. It's even worse than the internet would lead you to believe. |
|
|
 |
|
|
