|
Forum Rules | Firearms Safety | Firearms Photos | Links | Library | Lost Password | Email Changes |
Register | FAQ | Calendar | Today's Posts | Search |
|
Thread Tools | Search this Thread |
January 31, 2009, 06:18 PM | #1 |
Senior Member
Join Date: March 7, 2008
Posts: 265
|
Refinishing the stock on a Mosin Nagant what to do?
I'm thinking about refinishing the stock on my Nagant. What do I need to do to the stock to make this work? Thank you.
Nero45
__________________
Nero45 Revolvers are a disease. Once you buy one your doomed for life! Within temptation are our lives on this earth until we leave -me |
January 31, 2009, 06:39 PM | #2 |
Senior Member
Join Date: March 16, 2007
Location: Southern Arizona
Posts: 3,888
|
You can do a search of this site for numerous previous inquiries on the same subject. Here's a suggested link from an earlier thread on stock refinishing:
http://hunting.about.com/od/guns/a/aastockrefinish.htm |
February 1, 2009, 10:03 AM | #3 |
Senior Member
Join Date: October 7, 2006
Location: mid west Georgia
Posts: 102
|
Are you restoring it or do you want to sporterize it? If you are restoring it soak it in a good paint remover and scrub it with fine steal wool, once you have it clean a hot iron and damp cloth will lift out some of the smaller dents and dings. Try to sand as little as possible with very fine paper 300 grit or finer. Minwax makes a wipe on poly that works good, the more coats the more shine. Don't forget to coat the inside to seal it.
If you want to sporterize it, go out and get a walnut plank and start from scratch. I made a realy nice thumb-hole stock for a Arisaka 99 that I got for under a $100 because someone had already butchered the original stock Last edited by KEN K; February 1, 2009 at 10:11 AM. Reason: aditional info |
February 6, 2009, 11:02 AM | #4 |
Senior Member
Join Date: February 11, 2006
Posts: 481
|
Acetone and 0000 steel wool is good at getting the old finish off and so is L.A. Awsome sold at the Dollar Store. Make sure you have all the cosmoline out of the stock also. I use a heat gun and wipe it off as it comes boiling out. Then I wash it with soap and water and let it dry.
If you want the original look, Min Wax Red Mahogany stain will match it. The stock also had a few coats of shellac on it. Shellac dries very fast so you can put several coats on it in one day with a 0000 steel wool rub down in between coats. I did this to mine and it came out looking exactly like the original finish. |
|
|