October 11, 2009, 01:12 PM | #1 |
Senior Member
Join Date: August 17, 2009
Location: South West Florida
Posts: 139
|
Butler Creek folder ?
I just picked up a Ruger mini-30 with a B/C folding stock and I want to use a 6 to 9 inch Harris bi-pod.
The factory sling swivel is mounted to the left side of the gas block, so I will need to mount a QD stud in the bottom of the forend. There is very little clearance from the inside of the forend to the operating rod, not enough for a nut. How do I best mount a QD stud 2 inches or so behind the gas block, tough enough to withstand the pounding from the bi-pod ? Thanks, Paul |
October 14, 2009, 04:00 PM | #2 |
Senior Member
Join Date: August 17, 2009
Location: South West Florida
Posts: 139
|
Hey, did I put this post in the wrong place? (I'm a newbie on this board) 3 days, 26 reads, and not even a YPDB response. Thanks, Paul.
|
|
|