February 9, 2008, 05:23 PM | #1 |
Junior Member
Join Date: February 9, 2008
Posts: 2
|
SKS - Trigger Safety
Hoping someone has encountered this before; following disassembly / reassembly of Yugu SKS M59/66A1, I can't release the trigger safety.
I've repeated disassembly to inspect trigger group / magazine, and all appears ok. No other problems with reassembly. Just cannot release trigger safety . . . All suggestions appreciated! |
February 9, 2008, 10:18 PM | #2 |
Senior Member
Join Date: December 26, 2004
Location: Louisville KY
Posts: 13,806
|
Probably in the wrong position when you reassembled the trigger group. A little fuzzy on how it's done, but I remember the safety had to be either on or off when pulling it apart.
|
February 10, 2008, 11:22 AM | #3 |
Junior Member
Join Date: February 9, 2008
Posts: 2
|
SKS - Trigger Safety
The instructions I have indicate the Safety is to be ON and hammer cocked when the trigger group assembly is removed, and remains in this configuration when re-assembled.
I have attempted with the Safety both ON and OFF, however. The root-cause of the problem appears to be the Trigger Safety impinging on the Trigger Group lock-pin (the one which is depressed to remove the trigger group). Has anyone encountered this before? |
February 10, 2008, 05:29 PM | #4 |
Senior Member
Join Date: December 26, 2004
Location: Louisville KY
Posts: 13,806
|
|
February 22, 2008, 11:27 PM | #5 |
Junior member
Join Date: August 5, 2007
Location: Florida
Posts: 1,982
|
maybe this will help
|
|
|