|
Forum Rules | Firearms Safety | Firearms Photos | Links | Library | Lost Password | Email Changes |
Register | FAQ | Calendar | Today's Posts | Search |
|
Thread Tools | Search this Thread |
April 9, 2001, 01:33 PM | #1 |
Staff
Join Date: April 13, 2000
Location: Northern Virginia
Posts: 41,390
|
Especially on a hammer sear seat?
Any tips, hints, precautions? A friend gave me his used 29 to look at, and among other things I discovered that someone had been mucking around with the sear seat and cut through the case hardening. I'm going to recut the sear seat and hopefully use the Kasenit to reharden it.
__________________
"The gift which I am sending you is called a dog, and is in fact the most precious and valuable possession of mankind" -Theodorus Gaza Baby Jesus cries when the fat redneck doesn't have military-grade firepower. |
April 10, 2001, 09:15 AM | #2 |
Staff Alumnus
Join Date: October 12, 1998
Location: Earlington KY
Posts: 2,299
|
Mike, I've used it a lot over the years. Works just great for what you have in mind. Just follow the directions. George
|
April 10, 2001, 09:20 AM | #3 |
Junior member
Join Date: November 1, 1998
Posts: 109
|
Have used Kasenit to harden contact areas on a few small parts that I had to fabricate or modify myself and have had good luck so far vis a vis durability. Follow the direction carefully, and you should be good to go. Email any specific questions and I'll offer what help I can.
|
April 10, 2001, 09:57 AM | #4 |
Staff
Join Date: April 13, 2000
Location: Northern Virginia
Posts: 41,390
|
Thank you, Gents. That is just what I wanted to hear.
__________________
"The gift which I am sending you is called a dog, and is in fact the most precious and valuable possession of mankind" -Theodorus Gaza Baby Jesus cries when the fat redneck doesn't have military-grade firepower. |
|
|