|
Forum Rules | Firearms Safety | Firearms Photos | Links | Library | Lost Password | Email Changes |
Register | FAQ | Calendar | Search | Today's Posts | Mark Forums Read |
|
Thread Tools | Search this Thread |
April 25, 2005, 03:30 AM | #1 |
Member
Join Date: October 25, 2004
Posts: 83
|
nef shotgun disassembly/assembly
i have access to powder coating. i wanted to powdercoat the reciever of my nef single shot shotgun since most of the original finish is gone. will the reciever be hard to take apart/put together? ive dabbled with some pump shotguns guns but this will be new to me
|
April 25, 2005, 10:45 PM | #2 |
Senior Member
Join Date: July 19, 2004
Location: Ms
Posts: 1,160
|
$10 lifetime warranty
If you remove the parts and cannot put them back right, they provide a lifetime warranty for the amazing low fee of $10. I would hesitate to put any powder coating on the inside of the reciever as there are some close tolerances and the addition of the powder may may it hard to close the gun. On the outside it would be fine.
|
April 26, 2005, 01:01 AM | #3 |
Senior Member
Join Date: July 9, 2004
Location: Oklahoma by birth. America by the grace of God.
Posts: 635
|
Listen to cntryboy - do not powder coat the inside of the reciever or in the breech area! Do only the outer areas.
__________________
Quando Omni Flunkus Moritati (If all else fails - play dead!) Support the Second Amendment. Join the NRA > http://www.nra.org < Oklahoma State & Big 12 - #1 GO POKES!!!!! |
Thread Tools | Search this Thread |
|
|