|
Forum Rules | Firearms Safety | Firearms Photos | Links | Library | Lost Password | Email Changes |
Register | FAQ | Calendar | Search | Today's Posts | Mark Forums Read |
|
Thread Tools | Search this Thread |
January 23, 2000, 06:17 PM | #1 |
Senior Member
Join Date: November 4, 1999
Location: Alachua, FL., USA
Posts: 236
|
Just received my M/D holster, belt and mag pouch in the mail last Tuesday. The belt is 1 1/2" in width and although it fit the holster like a glove, the ammo pouch was about 1/2" too narrow. So what did I have to do? Before I knew what I was doing, I took out my trusty knife and cut a slit along the top and bottom of the notch and "wholla" the belt fit through nice and snug. Now the problem, how do I keep the "slit" from increasing in size? I was thinking about getting a leather punch and putting in a stitch, any suggestions?
Jon |
January 23, 2000, 06:54 PM | #2 |
Senior Member
Join Date: December 31, 1999
Location: Middle Georgia, USA
Posts: 13,198
|
CrociJA,
Try punching a nice clean hole centered exactly over the end of the cuts you made. |
January 24, 2000, 09:19 AM | #3 |
Member
Join Date: October 13, 1998
Location: The Woodlands, Texas
Posts: 83
|
You could have contacted ma and I would have taken care of it ASAP. In fact if it's a problem just drop me a line and I'll still take care of it.
------------------ www.customholsters.com M/D ENTERPRISES Custom Concealment Holsters Gunleather so nice it's almost a crime to conceal it [email protected] |
January 24, 2000, 05:02 PM | #4 |
Senior Member
Join Date: November 4, 1999
Location: Alachua, FL., USA
Posts: 236
|
Hehehe...Now that's what I call customer service. What are the chances? I just may take you up on your offer Mark. However, the LF-1 class is in another month, so I might just want to hang on to it until then.
Going to the range next weekend, and I want to have the entire rig to get used to it. Thanks! Jon |
Thread Tools | Search this Thread |
|
|