|
Forum Rules | Firearms Safety | Firearms Photos | Links | Library | Lost Password | Email Changes |
Register | FAQ | Calendar | Today's Posts | Search |
|
Thread Tools | Search this Thread |
September 11, 2005, 07:52 AM | #1 |
Member
Join Date: January 9, 2005
Location: Perry County Indiana
Posts: 67
|
Need info on ASM 1st model Dragoon
Does anyone have an Armi San Marco 1st model Dragoon? I need to know the diameter of the cylinder pin. All I need is the measurement of where the cylinder rides. It is an ASM.
Thanks, Lee |
September 13, 2005, 08:57 AM | #2 |
Junior Member
Join Date: September 13, 2005
Posts: 10
|
My ASM Dragoons both measure .569 inch as near as I can read my dial caliper--they are first and third models. The center hole in the cylinder measures .572 on one and .571 on the other.
On both of these ASM Dragoons, the chambers came undersized and gave 6 or 7 inch groups at 20 yards. On one of them I reamed the chambers out, increasing them from about .448 to a uniform .450--now that pistol gives 2 to 3 inch groups at the same range. I used a dowel wrapped in sandpaper and reamed the front third of the chambers by hand, checking my progress frequently. When I have time, the other gun will get the same treatment. |
September 14, 2005, 06:42 AM | #3 |
Member
Join Date: January 9, 2005
Location: Perry County Indiana
Posts: 67
|
Diameter
Howdy saaman,
Thank You Very Much for the measurement. It is just what I needed. I don't know about the chamber measurements yet, I don't have a cylinder. For my hobby, I buy parts/pieces of black powder revolvers and rebuild them. It is something to do with my retirement time and a lot of satisfaction to take a "dead" gun and make it "live" again. Again, Thank You, Lee |
September 14, 2005, 07:30 AM | #4 |
Junior Member
Join Date: September 13, 2005
Posts: 10
|
I do the same thing though I just now retired. Used to repair cap n ball revolvers for gunfight re-enactors and they were very rough on guns, so I have a lot of experience.
|
September 14, 2005, 01:07 PM | #5 |
Junior member
Join Date: December 6, 2001
Posts: 1,536
|
I'm glad you showed up and told him. Saaman got that asm dragoon shooting really good.
below are pictures of saaman's asm dragoon Last edited by mec; August 28, 2010 at 09:22 PM. |
September 15, 2005, 07:52 AM | #6 |
Member
Join Date: January 9, 2005
Location: Perry County Indiana
Posts: 67
|
ASM measurements
The measurements were what I needed to know that what I had was not a 1st model dragoon. What I bought is a frame with all the internals. It has the rounded grip cutouts like the Walker, but it has a cylinder pin diameter of .589". Now I think it may be from an ASM Whitneyville Hartford Dragoon.
That is why I am doing this. Learn a lot and uses a lot of time. Lee |
|
|