The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > Handloading, Reloading, and Bullet Casting

Reply
 
Thread Tools Search this Thread
Old June 2, 2006, 03:04 PM   #1
Kelly J
Senior Member
 
Join Date: April 29, 2006
Location: Blue Springs, MO
Posts: 383
Response From Dillon

I just heard from Dillon about my problem, of insufficiant tension to hold the bullet in the case under recoil from my 625 Mountain gun, 10.5 gr. HS-6 Powder 250GR LRNFP Bullet.To start with they have replaced the Resizing die, the Powder funnel/ Expander Die, the crimp die, none of these things cured the problem, as there was no increase in the Dementions to do anything to the case bullet tension.
It was desided to go ahead and change the 45 Colt resizing Die for the 45 ACP resizing Die and just not tell the Machine it is Resizing with the wrong Sizeing Die, so to make a long story short that is the game plan at this point in time, now all I need to do is get me a Good Chronograph so I can start working up loads to get back to where I think I should be with the HS-6 Powder and to confirm that the load can be handeled in the Mountain Gun.
__________________
"If ye love wealth better than liberty, the tranquility of servitude than the animating contest of freedom, go from us in peace. May your chains sit lightly upon you, and may posterity forget that ye were our countrymen!"
--Samuel Adams
Kelly J is offline  
Reply

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 03:38 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2021 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Page generated in 0.06135 seconds with 10 queries