RRA A2 rear sight chopped handle.

Sweet Shooter · December 7, 2012, 01:03 AM

I just bought this sight... for a handle type sight it's a bit spendy but I have to say it is primo engineering. Clicks are sure, and it looks super cool. Much nicer than any other non-flip rear I have tried. I can't wait to sight this in. It's my primary iron for my M400.
-SS-

madcratebuilder · December 7, 2012, 09:16 AM

Like this LMT A2 rear sight?

I didn't care for the larger thumb nut so I cut it down and have a small lock-nut installed.

Sweet Shooter · December 7, 2012, 05:07 PM

Similar... the RRA doesn't have the single big wheel nut... instead has two hex wrench bolts and a heavy side rail clamp. I did look at those LMT but wanted one without the big wheel nut... also the RRA looked and felt much tighter...

-SS-

December 7, 2012, 01:03 AM	#1
Sweet Shooter Senior Member Join Date: June 17, 2011 Posts: 672	RRA A2 rear sight chopped handle. I just bought this sight... for a handle type sight it's a bit spendy but I have to say it is primo engineering. Clicks are sure, and it looks super cool. Much nicer than any other non-flip rear I have tried. I can't wait to sight this in. It's my primary iron for my M400. -SS-

December 7, 2012, 05:07 PM	#3
Sweet Shooter Senior Member Join Date: June 17, 2011 Posts: 672	Similar... the RRA doesn't have the single big wheel nut... instead has two hex wrench bolts and a heavy side rail clamp. I did look at those LMT but wanted one without the big wheel nut... also the RRA looked and felt much tighter... -SS- Last edited by Sweet Shooter; December 18, 2014 at 06:09 PM.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search

December 7, 2012, 09:16 AM	#2
madcratebuilder Senior Member Join Date: November 2, 2007 Location: Northern Orygun Posts: 4,923	Like this LMT A2 rear sight? I didn't care for the larger thumb nut so I cut it down and have a small lock-nut installed.